8
STARTING UP THE MULTIPLE CPU SYSTEM
Set parameters for non-multiple CPU system.
Write set parameters in the hard disk/floppy disk.
(From previous page)
Completed
Diagram 8.8 Parameter setting procedure for new multiple CPU system creation
8.2 Setting Up the Multiple CPU System Parameters
8.2.2 Parameter setting for the Universal model QCPU
Control PLC (mandatory item)
Select Control PLC for each slot.
Selectable numbers depend on the CPU module
used.
Q02UCPU: PLC No.1 to PLC No.3
Except the Q02UCPU: PLC No.1 to PLC No.4
1
2
3
4
5
6
7
8
8
- 22