Mitsubishi MELSEC-Q Series User Manual page 242

8
STARTING UP THE MULTIPLE CPU SYSTEM
Note6 Note7
Basic
Note8.5
Basic Process
Note8.6
Write set parameters in the hard disk/floppy disk.
Note6
Basic
Note8.5
Note7
Basic Process
Note8.6
8
- 9 8.2 Setting Up the Multiple CPU System Parameters
8.2.1 Parameter setting for the Basic model QCPU,High Paformance model QCPU,Process CPU
(From previous page)
Set parameters for non-multiple CPU system.
Completed
Diagram 8.4 Parameter setting procedure for new multiple CPU system creation
Since the number of mountable CPU modules is three when using a Basic model QCPU, "PLC
No.4" is not selectable.
For the Basic model QCPU or the Process CPU, using the AnS/A series compatible I/O modules
and special function modules is not allowed.
Control PLC (mandatory item)
Select control PLC (PLC No. 1 to PLC No. 4)
Note 8.5
for each slot.
For the intelligent function module of function
version A, set Control PLC to PLC No. 1.
For the AnS/A series-compatible module, set
Control PLC to all same High Performance
Note 8.6
model QCPU.