Reset The H2 Stationary Graingage To Factory Settings - Juniper HarvestMaster GRAINGAGE H2 STATIONARY User Manual

H2 Stationary GrainGage User's Guide
The following table displays the typical preferred setting for each item on this screen.
System Settings
Item
Debug Streaming
Enabled
GrainGage Type
Isolation Gate
Mode
2. 3.8 Reset the H2 Stationar y GrainGage to Factor y Settings
Mirus and H2 Stationary GrainGage Setup
Default Value Description
This enables debug streaming messages for the DSP
module . Enabling this is only recommended when
No
troubleshooting the GrainGage with a HarvestMaster
Field Service Engineer .
Stationary Designates which GrainGage type is connected to Mirus .
Not used with the H2 Stationary GrainGage .
Normally Open
Controls the initial state of the isolation gate . In some
situations, closed is preferred .
This option can be found on the Setup > H2 GrainGage >
Factory Reset screen.
CAUTION: This cannot be undone! Resetting
the GrainGage to factory defaults will clear all
your settings, including actuator timers and
weight calibrations. This should only be done in
consultation with a HarvestMaster Field Service
Engineer.
31