Table of Contents
Advertisement
H2 Stationary GrainGage User's Guide
The following table displays the typical preferred setting for each item on this screen.
Weight Sensors Settings
Setup Parameter
Evacuation Time
Load Cell
Coefficients
Weigh Time
Weight Tare
Warning
Note: Preconfigured values are default values based on generalized harvest conditions. They may not
reflect the optimum settings for the harvest conditions for your particular climate, fields, or grains.
Changing default values requires a certain level of experience. Please contact HarvestMaster Field Service
Engineers when adjusting these settings. See 8.4.2 Contact a HarvestMaster Field Service Engineer on
page 93.
Mirus and H2 Stationary GrainGage Setup
Default Value
Description
The amount of time the evacuation gate remains open to
allow for the evacuation of all grain from the weigh bucket .
This setting overrides the open state time for the evacuation
2000 msec
gate .
Caution: Wetter grain or oil seeds may require longer
evacuation times.
The default values for load cell coefficients are placeholders .
These are custom values that are generated during weight
2 .000
calibration . They are used to convert millivolt readings from
the load cells into pounds or kilograms .
The period over which weight readings are averaged .
1000 msec
A shorter weigh time may reduce the accuracy of the
measurement .
0 .500 lb
This is the threshold above which a tare warning is
(0 .227 kg)
generated after weigh bucket evacuation .
28
Advertisement
Table of Contents
