Xerox WorkCentre 5022 Service Manual page 72

024-952 Tray 3 No Paper
BSD-ON: CH7.7
One of the following errors was detected. However, this is not detected until the paper is about
to be fed.
• During Copy Job or Print Job, Tray 3 was selected but Tray 3 has run out of paper and the
ATS function for Tray 3 is disabled. This also includes the cases where Tray 3 was
selected by the System Controller due to APS result.
• During Copy Job or Print Job, Tray 3 was selected by the System due to APS result but it
was detected that Tray 3 has run out of paper and the machine is unable to ATS to other
Trays.
Cause/Action
Perform any of the following:
• Press [Stop] on the UI Panel.
• Load paper into Tray 3.
• If this had occurred during ATS, load paper with the same settings as for Tray 3 into other
than MSI.
If the problem persists, check the following:
• The Tray 3 paper supply mechanism for damage and foreign substances.
• The Tray 3 No Paper Sensor for contamination, improper installation, and Actuator opera-
tion failure.
• Tray 3 No Paper Sensor: Input Check [072-102] (PL 11.3)
• The connection between the Tray 3 No Paper Sensor J102B and the 2TM PWB J549 for
open circuit, short circuit, and poor contact.
If no problems are found, replace the following parts in sequence:
• 2TM PWB (PL 11.6)
• ESS/MCU PWB (PL 18.3)
Status Indicator RAPs
024-952 Tray 3 No Paper
024-953 Tray 4 No Paper
BSD-ON: CH7.8
One of the following errors was detected. However, this is not detected until the paper is about
to be fed.
• During Copy Job or Print Job, Tray 4 was selected but Tray 4 has run out of paper and the
ATS function for Tray 4 is disabled. This also includes the cases where Tray 4 was
selected by the System Controller due to APS result.
• During Copy Job or Print Job, Tray 4 was selected by the System due to APS result but it
was detected that Tray 4 has run out of paper and the machine is unable to ATS to other
Trays.
Cause/Action
Perform any of the following:
• Press [Stop] on the UI Panel.
• Load paper into Tray 4.
• If this had occurred during ATS, load paper with the same settings as for Tray 4 into other
than MSI.
If the problem persists, check the following:
• The Tray 4 paper supply mechanism for damage and foreign substances.
• The Tray 4 No Paper Sensor for contamination, improper installation, and Actuator opera-
tion failure.
• Tray 4 No Paper Sensor: Input Check [072-103] (PL 11.3)
• The connection between the Tray 4 No Paper Sensor J102A and the 2TM PWB J549 for
open circuit, short circuit, and poor contact.
If no problems are found, replace the following parts in sequence:
• 2TM PWB (PL 11.6)
• ESS/MCU PWB (PL 18.3)
06/2014
2-50
Version 1.0
WC 5022/5024