Xerox WorkCentre 5022 Service Manual page 437

6.1.10 Installation Environment
This machine can be operated under the following conditions:
• Temperature: 10 Degree Celsius to 32 Degree Celsius
• Humidity: 15 to 85% (with no condensation)
• Altitute: 0 to 2,500 m
Version 1.0
WC 5022/5024
6.1.11 Warm Up Time
The time required before print operation can start after the main power is turned ON or after the
Sleep Mode and the Low Power Mode is cancelled is as follows.
Measurement Rated at 20 Degrees Celsius/65% RH.
Conditions Toner Recovery and Setup Cycle are not included.
Power ON after seasoning when the power has been OFF for 3 hours or
longer.
Basic Configura- Standard Main Unit
tion
*1: [Time taken from power ON to the UI entering the Standby state] or
the time equal to [Power ON to 1st sheet is output] - [Standby to 1st sheet is output]
Configuration Immediately after main power is turned ON*1
WC 5022/5024 19 s or faster
*1: [Time taken from power ON to the UI entering the Standby state] or
the time equal to [Power ON to 1st sheet is output] - [Standby to 1st sheet is output]
06/2014
6-9
Table 1
Table 2
6.1.10 Installation Environment
General