Table of Contents
Advertisement
6.5.2.5 Component Check
Purpose
Displays the logic state of Input Component input signals and operates the Output Compo-
nents.
NOTE: For more details on the Component Check Code, refer to 6.3.1 and 6.3.2 in Chapter 6.
Procedure
1.
Enter the CE Diag Mode.
2.
Input the Chain-Link No. and press <Start>.
NOTE: E.g.) The machine does not accept '005-1' as an abbreviation of '005-001'. When
a number starts with '0', the '0' must be entered.
3.
When this is in progress, the message [In progress] is displayed on the UI.
<Input Component Check>
•
The electrical level (High or Low) of the monitored component is displayed on the UI
with a refresh rate of 3 times per second
•
It is not possible to input several Chain-Link No. at the same time to perform moni-
toring.
•
As there is no item with automatic timeout, the process will run until <Stop> is
pressed.
<Output Component Check>
•
The target component is activated.
•
It is not possible to input several Chain-Link No. at the same time to perform activa-
tions.
•
For the item that does not stop automatically, press <Stop> to stop its operation.
4.
Pressing <Stop> displays [Done] on the UI.
5.
Pressing <Clear (C)> returns you to the [Diagnostics Mode Base] screen.
Version 1.0
WC 5022/5024
6.5.2.6 Maintenance Report
Purpose
Prints the Maintenance items that can be set from and displayed on the CE Mode.
Procedure
1.
Enter the CE Diag Mode and input 999-980 in the Chain-Link.
2.
Pressing <Start> prints the Maintenance Report using the following settings.
•
1 Sided Print - fixed. (The Maintenance Report cannot be printed using 2 Sided.)
•
Quantity: 1 - fixed.
3.
When this is in progress, the message [In progress] is displayed on the UI.
4.
Once the Maintenance Report has been printed, [Done] will be displayed on the UI.
5.
Pressing <Clear (C)> returns you to the [Diagnostics Mode Base] screen.
06/2014
6-107
General
6.5.2.5 Component Check
- Quick Links:
- Rep 8.1.1 Drum Cartridge
Hide quick links:
Advertisement
Chapters
Table of Contents
