Xerox WorkCentre 5022 Service Manual page 119

045-310 Image Ready Error
BSD-ON: CH3.3
Unable to send the Image-valid signal cannot within the specified time.
NOTE: When the attempt to expand the image has failed, [016-776 Marker Code Detection
Fail] occurs after the recover operation.
Cause/Action
1. Check the following:
• The Net Cable for poor connection.
• The USB Cable (Local) for poor connection.
• The connector ( P/J425) between the ESS/MCU PWB and the NET I/F PWB for poor
contact.
2. Upgrade the Controller Firmware.
ADJ 18.2.3
3. If no problem is found, replace the ESS/MCU PWB. (PL 18.3)
Version 1.0
WC 5022/5024
045-313 IOT Logic Fail
BSD-ON:-
The IOT Software error was detected.
Cause/Action
1. Turn the power OFF and ON.
2. Install the correct version of the IOT firmware.
3. If the problem persists, replace the ESS/MCU PWB. (PL 18.3)
06/2014
2-97
Status Indicator RAPs
045-310 Image Ready Error