Xerox WorkCentre 5022 Service Manual page 532

6.5.1.2 How to Enter the CE Diag Mode
Procedure
Enter the CE Diag Mode by the following procedure.
1. Inform the customer that the machine will be temporarily unavailable for use (inform that
all Copy. Local Print, Fax Jobs, etc. will stop) as it is going to be serviced.
2. Disconnect the machine from the customer's network.
3. Make sure that there is no Job, such as Copy, Print, or Fax, etc. that is in progress at the
machine. Also check that there are no Stored Jobs.
4. Press and hold the <0> key on the Control Panel for 4 seconds or longer and then press
<Start> while keeping your finger on the <0> key.
5. The [CE - Type Passcode] screen will be displayed.
Table 1
CE Mode
Please Input Entry Passcode
[ ]
6. Use the keypad to enter the Passcode [6.7.8.9] and select [OK].
7. The [Diagnostics Mode Base] screen will be displayed.
Table 2
CE Mode
Chain-Link# -
8. Perform the various diagnostics by inputting the Chain-Links on the [Diagnostics Mode
Base] screen.
General
6.5.1.2 How to Enter the CE Diag Mode
6.5.1.3 How to Exit from the CE Diag Mode
Do not leave the machine unattended while it is in the CE Diag Mode.
Procedure
Turn the power OFF and ON.
06/2014
6-104
CAUTION
WC 5022/5024
Version 1.0