Adjusting The Media Feed Quantity - Ricoh Pro TF6251 Operating Instructions Manual

3. Basic Operations

Adjusting the Media Feed Quantity

Adjust the media feed quantity in the following cases:
• Horizontal lines are misaligned.
• Print image quality defects such as uneven density occur.
• Media has been replaced with different media.
You cannot print a test pattern on narrow media. When adjusting the media feed quantity, use media
that has a width of 297 mm (approx. 11.7 inches) or more.
• Before executing this after positioning the media, carry out a test print (nozzle check pattern).
• Do not adjust the media feed to the part where the media has been fed and moved back. Doing so
may cause problems with the adjustment to the part moved back, such as leaving roller marks on it.
If this happens, press [ ] to feed the media.
• Perform no other operations while the test pattern is printing.
• An error will occur and test pattern will not print if:
• There is a misfeed.
• The machine is performing maintenance operations.
• The machine has run out of ink.
• The machine has run out of media.
• Before adjusting, ensure that there is no media floating or skewing. If such issues occur, feed the
media from the [Origin Setting] screen to reset the media or to resolve the skewing.
• If nozzle clogging or bending lines occur, the machine cannot perform the adjustment successfully.
We recommend performing head cleaning before adjusting.
Adjusting the Media Feed Quantity
Print the inspection and adjustment patterns to adjust the media feed quantity.
58