Ricoh Pro TF6251 Operating Instructions Manual page 15

12. Guide roller
Feeds media from the pinch roller to the winding unit.
13. Tension roller
Tightens media to prevent the media from slacking.
14. Roll shaft of winding unit
Sets the roll core for rolling up media.
15. Roll shaft of feeding unit
Used to set roll media.
Front view/control section
1 2 3 4 5
1. Power lamp
Lights when the machine is turned on.
2. Vacuum pressure control
Adjusts the pressure used to vacuum the media on the table. Adjust the vacuum pressure to strengthen the
vacuuming of the media if the media becomes out of position or when using warped media. This is effective
when the vacuum ON/OFF button is on.
3. Vacuum ON/OFF button
Turns on and off media suction. If switched on, suction is applied to the media through the holes in the platen.
4. UV1 lamp ON/OFF button
Turns on and off the UV1 lamp.
5. UV2 lamp ON/OFF button
Turns on and off the UV2 lamp.
6. Pin ON/OFF button
Sets the positioning pins built into the table.
7. Standby button
Used to enter standby state.
6 7 8
M563IC0003
Guide to Names and Functions of Components
13