Ricoh Pro TF6251 Operating Instructions Manual page 40

3. Basic Operations
If the ends of the roll media are not flat, be sure to flatten them by pushing in the protruding ends before
loading the media. Not correcting this problem may cause the media to fold over at the edge or crease
and skew during printing.
Before loading the roll media, decide whether the inner or outer surface of the roll media will be the
print surface, and whether the printing surface will be wound facing inward or outward.
• If the inner surface of the media is the printing surface, pull out the media from the upper side of the
feed roller.
• If the outer surface of the media is the printing surface, pull out the media from the lower side of the
feed roller.
• If the media is wound with the printing surface facing inward, wind the media from the lower side of
the winding roller.
• If the media is wound with the printing surface facing outward, wind the media from the upper side
of the winding roller.
A figure showing how to set the media is affixed to the right side of the main unit. Refer to it as necessary.
1
2
1. Printing surface is inside
2. Printing surface is outside
1. Press the power on/off button on the front of the machine.
The power lamp turns on.
38
2
1
M563IC0029
M563IC0105