Ricoh Pro TF6251 Operating Instructions Manual page 44

3. Basic Operations
8. Close the clamp covers at both ends of the roll shaft of the feeding unit so the fixing levers
engage.
2
1. Clamp cover
2. Fixing lever
9. Center the roll media on the roll shaft of the feeding unit.
1. Media
2. Roll core of the winding unit
• When putting the roll core on the roll shaft of the winding unit, align the right end of the roll
core with the right end of the media loaded on the roll shaft of the feeding unit.
• During printing, maintenance is executed periodically to keep the print heads working
correctly. Depending on the loading position of the media, printing may slow down slightly.
• Loading the media at the edge of the platen may cause creasing. If this happens, load the
media at the center.
• The media detection sensors are located in two positions, namely the center and right edge of
the platen, as shown below. Load the media in a position where it will be conveyed above
one or both of the sensors. Printing is possible if the media is detected by one or both of the
sensors. If neither sensor detects the media, an error occurs, reporting that the media has run
out.
42
1
M563IC0041
2
1
M563IC0134