Ricoh Pro TF6251 Operating Instructions Manual page 54

3. Basic Operations
27. Press the air injection connector against the air injection port on the roll shaft of the
winding unit to inject air.
Align the right end of the roll core for the winding unit with the right end of the roll core for the
feeding unit.
1
1. Air injection connector
(A) shows the cross-section of the roll shaft before injecting air. After injecting air, visually check
that the roll core clamps have extended and come in contact with the inside of the roll core, as
shown in (B). Then, turn the roll core by hand to check that the roll core does not slip on the shaft.
(A)
1
1. Roll core clamp
2. Roll core
3. Roll shaft
28. Align the right edge of the roll media that is mounted on the roll shaft of the feeding unit
and the right edge of the roll media that was passed out.
• If it is difficult to align the right edge of the roll media, feed more of the media before trying to
align it.
• On the platen, check that the media is not adhered to anything and is not loose or misaligned.
• If the media is adhered to something or is loose or misaligned, move the media back and forth
as needed to solve the problem and then align the position of the right end.
52
M563IC0018
(B)
1
2
3
2
3
M563IC0040