3. Basic Operations
1. Roll core clamp
2. Roll core
3. Roll shaft
11.
Release the fixing levers at both ends of the roll shaft of the winding unit, and raise the
clamp covers.
The right gear cover is interlocked with the right clamp cover and opens when the clamp cover is
lifted.
If the roll shaft has been set to the winding unit, remove the roll shaft from the the winding unit by
following the same procedure as for removing the roll shaft from the feeding unit.
1
1. Fixing lever
2. Clamp cover
12.
Insert the roll core into the roll shaft of winding unit.
Until installing the roll shaft of the winding unit in Step 25, keep it on a flat surface where it does not
get soiled.
1. Roll shaft of winding unit
2. Roll core
44
2
M563IC0044
2
1
M563IC0015