Table of Contents
Advertisement
You can reduce waste media without rewinding by using the "Prevent Drying After
Printing" function on page 47.
3. The media edge may have touched the floor.
If the media edge comes into contact with the floor and the media is pulled to one side,
a media skew occurs. Use the roll-up unit to prevent the media edge from touching the
floor.
STEP1-2 If the media feed quantity is not correct
1. You have not adjusted feed quantity and drop position.
Perform the feed quantity adjustment when change the media, because optimal feed
quantity differs for each media.
See the section "Adjusting the Media Feed Quantity" in the manual "Operating
Instructions".
2. The media feed was adjusted in the part where the media has been fed and
moved back or the media is deformed due to heating.
Parts of media moved back at once has damage due to the heater temperatures and
registration roller.
If you adjust the media feed quantity in the damaged part, a problem such as uneven
density, white lines, or black lines may occur on the media that is undamaged because
the optimal feed quantity may differ between the damaged and undamaged parts.
If this happens, adjust the media feed quantity in the unrewound part.
STEP2 Adjust the actual image by Media Feed Correction
If STEP 1 does not solve the uneven density, try the STEP2 solutions.
STEP2 has three options.
1. Adjust the image with the Media Feed Correction.
2. Print by upper print mode.(for example.16pass is upper print mode of 12 pass.)
3. Change to compatible media. Please contact your retailer or service representative for
compatible media information.
・Media Feed Correction
The uneven density can be improved by using "Media Feed Correction".
Media Feed Correction Level0
You can select the level of media feed correction from level 0 to level 3.
Typically, it is recommended to set Level 0.
If you can see any uneven density, change the setting to level 1.
Media Feed Correction Level1～
12
Advertisement
Table of Contents
