Table of Contents
Advertisement
Operating
Temporarily freezing the screen
Press the FREEZE button on the remote control.
The "FREEZE" indication appears on the screen
(however, the indication does not appear when the
SILENT or INHIBIT is selected for the OSD MESSAGE
item in the SETUP (89)), and the projector goes into
the FREEZE mode, which the picture is frozen.
To exit the FREEZE mode and restore the screen to normal, press the
FREEZE button again.
NOTE
• The projector automatically exits from the FREEZE mode when some
control buttons are pressed.
• If the projector continues projecting a still image for a long time, the LCD
panel might possibly be burned in. Do not leave the projector in the FREEZE
mode for too long.
• Images might appear degraded when this function is operated, but it is not a
malfunction.
Temporarily shading the screen
Press the SHUTTER button on the control panel.
Light source output is turned off.
To open the shutter and restore the screen, press
the SHUTTER button again.
CAUTION
shutter function above or the AV MUTE function (44). Any other action may
cause the damage on the projector.
NOTE
• The projector turns off automatically when the time set up by the
SHUTTER TIMER passes (100) .
• When turning off the projector by the normal procedure with the shutter function
on, the function is automatically set to off.
• Refer to "Regarding the indicator lamps"(131) about the indicator when the
shutter function is on.
►If you want a blank screen while the light source is lit, use the
6 0
FREEZE
NETWORK INTERACTIVE
button
INFO
SHUTTER button
QM00971-1
Advertisement
Table of Contents
