Table of Contents
Advertisement
PbyP (Picture by Picture) / PinP (Picture in Picture)
The PbyP / PinP is a function for displaying two different picture signals on a
screen that is separated into main and sub areas for each signal.
PbyP
NETWORK INTERACTIVE
button
INFO
Press the PbyP button on the remote control. This activates the PbyP mode.
Then, press the PbyP button again. The projector goes into PinP mode. The
screen which is displayed before the PbyP button was pressed is displayed as the
main area. Most of operations are effective for the main area only.
To quit the PinP mode, press the PbyP button again.
NOTE
• If the LAN port is selected when the PbyP button is pressed, input
from other port is displayed on the main area.
• When in the PbyP / PinP mode, use the MENU button on the remote control
or ▲/▼ buttons on the control panel to display the OSD menu.
• Some functions that cannot be used when in the PbyP / PinP mode.
• Normally a message is displayed when buttons that cannot be used are
pressed (130). However, the messages are not displayed for some unusable
buttons.
• The functions on the OSD menu that cannot be used are displayed in gray
and cannot be selected.
• When in the PbyP / PinP mode, image quality may deteriorate.
(continued on next page)
ð
Normal mode
main
sub
ð
area
area
PbyP mode
6 1
Operating
main
area
sub area
PinP mode
QM00971-1
Advertisement
Table of Contents
