Table of Contents
Advertisement
Setting up
Connecting with your devices
Before connecting the projector to a device, consult the manual of the device to
confirm that the device is suitable for connecting with this projector and prepare
the required accessories, such as a cable in accord with the signal of the device.
Consult your dealer when the required accessory did not come with the projector
or the accessory is damaged.
After making sure that the projector and the devices are turned off, perform
the connection, according to the following instructions. Refer to the figures in
subsequent pages.
Before connecting the projector to a network system, read Network Guide too.
WARNING
cause a fire or damage the projector and devices.
• Use only the accessories specified or recommended by the projector's
manufacturer. It may be regulated under some standard.
• Neither disassemble nor modify the projector and the accessories.
• Do not use the damaged accessory. Be careful not to damage the accessories.
Do not place the projector or heavy objects on the power cord and cables.
Also, do not place a spread, cover, etc., over them because this could result
in the inadvertent placing of heavy objects on the concealed power cord or
cables. Route a cable so that it is neither stepped on nor pinched out.
• Do not place the cord near the heater or the exhaust vents of the projector.
• Do not pull the power cord and cables. When connecting and disconnecting the
power cord or cables, do it with your hand holding the plug or connector.
• Do not throw or drag the cables.
• Do not attempt to work on the power cord.
• Avoid bending the power cord sharply.
CAUTION
with the core to the projector. Do not take the core of power cord away. That
may be required by EMI regulations.
(continued on next page)
►Use only the appropriate accessories. Otherwise it could
►For a cable with a core at only one end, connect the end
2 6
QM00971-1
Advertisement
Table of Contents
