Table of Contents
Advertisement
Operating
4. Selecting Blending Level
Select the BLENDING LEVEL with ▲/▼ buttons.
[1-25] can be selected with ◄/► buttons.
Adjust the brightness of the Blending Region according to the settings.
NOTE
• Blending Level adjustment is available only when MANUAL is
selected in MODE.
5. LIGHT OUTPUT
Adjusts the brightness of the projectors which are using Blending.
6. WHITE BALANCE
Adjusts the white balance of the whole screen.
6.1. OFFSET
Changes the color intensity on the whole tones.
6.2. GAIN
Mainly affects color intensity on the brighter tones.
7. BLACK LEVEL
Adjusts black color level of the projectors which are using Blending.
Adjusts the adjustment value of R/G/B at the same time when W is selected.
When each of R/G/B is selected, the adjustment value of R/G/B can be
adjusted respectively.
NOTE
• The positional deviation of the screen may occur after installing
the projector over time. Perform the screen adjustment again to correct the
positional deviation.
5 8
QM00971-1
Advertisement
Table of Contents
