Item
SERVICE
(continued)
(continued on next page)
Selecting this item displays COMMUNICATION
menu.
In this menu, you can configure the serial
communication settings of the projector using the
CONTROL port.
• Select an item using the cursor buttons ▲/▼.
Then pressing the ► button opens the submenu
for the setting item you selected. Or, pressing
the ◄ button instead of the ► button makes the
menu back to the previous one without changing
the setup. Each submenu can be operated as
described above.
• For the function of serial communication, refer to
COMMUNICATION
the Network Guide.
COMMUNICATION TYPE
Select the communication type for transmission
using the CONTROL port.
NETWORK BRIDGE: Select this type, if it is
OFF: Select this mode to receive RS-232C
• OFF is the default setting.
• When you select the NETWORK BRIDGE, check
the item, TRANSMISSION METHOD (112).
Description
required to control an external device as a
network terminal, using this projector from the
computer.
The CONTROL port does not accept RS-232C
commands (7. Network Bridge Function in
the Network Guide).
commands using the CONTROL port.
111
OPTION menu
QM00971-1