Table of Contents
Advertisement
Item
STANDBY MODE
(continued on next page)
Using ▲/▼ buttons switches the standby mode setting.
QUICK START: For quick start-up (Standby power increases).
When the projector is set to QUICK START and in standby
mode, POWER indicator blinks in Green 2 times for about 3
seconds. QUICK START is disabled in 30 minutes and the
mode switches to NORMAL standby.
In this case, POWER indicator lights in orange.
Startup screen is not displayed when the projector is started
in QUICK START.
Fan operates while QUICK START is enabled.
NORMAL: For using communication functions in the standby mode.
NETWORK(WOL): For using Wake on LAN (WOL) function
SAVING: Reduces power consumption minimally.
• When NETWORK(WOL) or SAVING is selected, the following
restrictions apply.
- The RS-232C communication control except to turn the projector
on are disabled while the projector is in the standby mode. If the
COMMUNICATION TYPE in the COMMUNICATION menu is set to
NETWORK BRIDGE, all of the RS-232C commands are disabled
111
(
) .
- STANDBY OUTPUT is invalid.
- The HDMI Link and HDBaseT
projector is in the standby mode.
- SCHEDULE function (Ex. POWER-ON) in the standby mode will
not be operated.
- It takes a while until the projector is available after starting up.
- The CENTERING feature while the projector is in the standby
mode is disabled if the STANDBY MODE item of SETUP menu is
set to NETWORK(WOL) or SAVING (
before the projector's power is turned off, or set the STANDBY
MODE to NORMAL or QUICK START.
• When NETWORK(WOL) is set, WIRED NETWORK in OPTION
menu > SERVICE > CONTROL TERMINAL is fixed to LAN.
• When NETWORK(WOL) is selected, only Wake on LAN (WOL) on
wired LAN is accepted while the projector is in the standby mode.
• This function is available only when OFF is selected for STACK
MODE.
• You cannot select NETWORK(WOL) when HDBaseT is selected in
SERVICE menu - CONTROL TERMINAL - WIRED NETWORK.
Description
on wired network while reducing power
consumption.
TM
functions are disabled while the
8 7
SETUP menu
50
) . Perform CENTERING
QM00971-1
Advertisement
Table of Contents
