Selecting An Aspect Ratio - Hitachi MP-WU8101W User Manual

Operating

Selecting an aspect ratio

Press the ASPECT button on the remote control.
Each time you press the button, the projector switches
the mode for aspect ratio in sequence.
 For a computer signal
NORMAL  4:3  16:9  16:10  ZOOM  NATIVE
, HDBaseT
 For HDMI
TM
NORMAL  4:3  16:9  16:10  14:9  ZOOM  NATIVE
 For a video signal or component video signal
4:3  16:9  16:10  14:9  ZOOM  NATIVE
 For an SDI signal
NORMAL  4:3  16:9  16:10  ZOOM  NATIVE
 For an input signal from the LAN port, or if there is no signal
16:10 (fixed)
NOTE
• The ASPECT button does not work when no proper signal is input.
• NORMAL mode keeps the original aspect ratio setting.
• You cannot select NATIVE when inputting 4K signal.
• If the ASPECT button is pressed when no signal is input, the pattern for
checking the aspect ratio is displayed. Use it to check the aspect ratio of a
screen when installing the projector. It disappears if the ASPECT button is
pressed again while the pattern is displayed.
, and DisplayPort
TM
4 6
NETWORK INTERACTIVE
INFO
TM signals
ASPECT
button
QM00971-1