Table of Contents
Advertisement
Issues that may be easy to be mistaken for machine defects
An issue may be confused with a machine defect, check and deal with it according
to the following table.
Issue
Power does not
come on.
Operations
other than
power on/off are
not available.
Neither sounds
nor pictures are
output.
(continued on next page)
Cases not involving a machine defect
The electrical power cord is not plugged in.
Correctly connect the power cord.
The main power source has been interrupted during
operation such as by a power outage (blackout), etc.
Disconnect the power plug from the power outlet, and
allow the projector to cool down at least 20 minutes, then
turn the power on again.
OSD MESSAGE is set to INHIBIT.
Press the OSD MSG button on the remote control for
more than 3 seconds to display the OSD MESSAGE
dialog, then change the setting.
The signal cables are not correctly connected.
Correctly connect the connection cables.
Signal source does not correctly work.
Correctly set up the signal source device by referring to
the manual of the source device.
The input changeover settings are mismatched.
Select the input signal, and correct the settings.
AV MUTE function is working.
Press AV MUTE button on the remote control.
Is the shutter function on?
Check if the shutter function is on by checking the
indicator.
Press the SHUTTER button on the control panel if the
shutter function is on.
Refer to "Regarding the indicator lamps" about the
indicator when the shutter function is on.
13 7
Troubleshooting
Reference
page
3 7
3 7
47, 89
26 ~ 34
–
4 5
4 4
6 0, 132
QM00971-1
Advertisement
Table of Contents
