Searching An Input Signal; Selecting An Aspect Ratio - Hitachi CP-AW100N User Manual

Operating

Searching an input signal

1.
Press the SEARCH button on the remote control.
The projector will start to check its input ports as below in
order to find any input signals.
When an input is found, the projector will stop searching
and display the image. If no signal is found, the projector will
return to the state selected before the operation.
COMPUTER IN1  COMPUTER IN2
VIDEO
● While the ON is selected for the AUTO SEARCH item in the OPTION menu
(49), the projector will keep checking the ports in above order repeatedly till
an input signal is detected.

Selecting an aspect ratio

1.
Press the ASPECT button on the remote control.
Each time you press the button, the projector switches the
mode for aspect ratio in turn.
 For a computer signal
NORMAL  4:3  16:9  16:10  NATIVE
 For an HDMI signal
NORMAL  4:3  16:9  16:10  14:9  NATIVE
 For a video signal, s-video signal or component video signal
4:3  16:9  16:10  14:9  NATIVE
 For no signal
16:10 (fixed)
● The ASPECT button does not work when no proper signal is inputted.
● The NORMAL mode keeps the original aspect ratio setting.
● The on-screen menu might be displayed outside of the image display
area depending on the adjustment value of the ASPECT, D-ZOOM and
KEYSTONE. Changing the values of ASPECT, D-ZOOM and KEYSTONE
may fix the symptom.
22
S-VIDEO HDMI
SEARCH button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
POSITION MENU
ENTER
ESC RESET
ASPECT button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
AUTO
ASPECT SEARCH BLANK
PAGE VOLUME
MAGNIFY FREEZE
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON MUTE
1 2
MENU
POSITION
ENTER
RESET
ESC