Adjusting Tilt Potentiometer Used With A Trcm, Tac Or Sac - Invacare 2G Tarsys Service Manual

NOTE: If drive lock-out light does NOT react as described in STEP 15, repeat procedure. If drive
lock-out light still does NOT react as described in STEP 15, DO NOT use unit. Contact Invacare
Technical Support at the number listed on the back cover.
DETAIL "B"
Single Function
Toggle Switch
Drive Lock-Out Light
To
Potentiometer
To Wiring
Harness

Adjusting Tilt Potentiometer Used With a TRCM, TAC or SAC

To adjust the tilt potentiometer on a seating system with a TRCM, TAC or SAC, follow
these steps:
1. Plug the remote programmer into the wheelchair TRCM controller.
2. Set remote programmer to the current status screen.
NOTE: For STEPS 1-2, refer to the MK
3. Measure the back angle relative to the seat. Verify angles by using magnetic protractor
(available at any hardware store).
4. Loosen the set screw on the tilt potentiometer.
Part No 1114842
DETAIL "A"
To Actuator
Connector
FIGURE 14.7 Adjusting the Tilt Potentiometer
electronics service manual supplied with wheelchair.
5
SECTION 14—ELECTRONICS
Set Screw
Tilt Potentiometer
Tilt Potentiometer
Located on Rear
Pivot Assembly
153
2G Tarsys®Powered Seating System
Side View
Set Screw
DETAIL "C"
Place Magnetic
Protractor
Here