Removing/Installing The Vsr Actuator; Removing - Invacare 2G Tarsys Service Manual

SECTION 13—TILT AND RECLINE
DETAIL "B"
Rear of Tilt
Locknut Actuator
Spacers
Rear Pivot
Assembly
FIGURE 13.4 Removing/Installing the Tilt Actuator

Removing/Installing the VSR Actuator

NOTE: For this procedure, refer to FIGURE 13.5.

Removing

1. Remove the VSR actuator shroud. Refer
to Removing/Installing VSR Shroud on
page 100.
2. Disconnect the VSR actuator connector
from the TRCM or TAC VSR actuator
connectors (Not shown).
3. Remove the hex bolt and locknut that
secure the existing VSR actuator to the
spreader bar.
NOTE: When the spreader bar is disconnected
from the VSR actuator, the back pan ASM may
slide out of position.
4. Remove the hex bolt, washers and
locknut that secure the existing VSR
actuator to the actuator mounting
bracket.
2G Tarsys®Powered Seating System
Tilt Actuator
Shoulder
Bolt
132
DETAIL "A"
Shoulder
Bolt
Spreader Bar
VSR
Actuator
Connector
VSR
Actuator
Hex Bolt
Locknut
Washers
FIGURE 13.5 Removing/Installing the VSR
Actuator
Front of Tilt
Actuator
Locknut
Front Pivot
Assembly
Hex Bolt
Locknut
VSR Actuator Bracket
Part No 1114842