Removing/Installing Center Seat Frame; Removing Center Seat Frame - Invacare 2G Tarsys Service Manual

SECTION 6—SEAT ADJUSTMENTS
Crossbeam
Coved
Socket
Locknuts
Center Seat
Washer
Hex Bolt
Screw*
Frame
Locknut
Spacers
Spacer
Coved Washer
Connecting
Bracket
Coved Washer
Hex Bolt
Hex Bolts
Locknuts
Side Frame
Spacer
NOTE: Tilt/Recline seat frame shown. *NOTE: Only on systems with recline.
FIGURE 6.13 Installing Side Frames

Removing/Installing Center Seat Frame

WARNING
Pinch points exist between seat and base frames. Use caution to avoid injury.
CAUTION
For Tilt/Recline and Recline-Only seating systems, the center seat frame assembly is
a non-serviceable part. Whenever a new center seat frame is required (e.g., to
achieve a desired seat width or depth), return the complete wheelchair to Invacare
for service.
NOTE: For this procedure, refer to FIGURE 6.14 on page 72.
NOTE: The following procedure is for Tilt-Only seating systems.

Removing Center Seat Frame

1. Remove the side shrouds. Refer to Removing/Installing Side Shrouds on page 100.
2. Remove the seat pan. Refer to Removing/Installing Seat Pan on page 54.
3. Remove the arms. Refer to Removing Armrests on page 114.
4. Remove the back. Refer to Back Adjustments on page 80.
5. Remove the legrests.Refer to Installing/Removing the Power Elevating Legrests on
page 104.
6. Remove the side frames. Refer to Removing/Installing Side Frames on page 66.
70
2G Tarsys®Powered Seating System Part No 1114842