Invacare 2G Tarsys Service Manual page 81

9. Reinstall the shoulder bolt, washer and locknut that secure the curved link to the rear
of the slide block and connector bracket and loosely tighten. Refer to FIGURE 7.1 for
hardware orientation.
10. Repeat STEPS 8-9 for the opposite side of the seat frame.
11. Torque all locknuts to 13 ft-lbs ± 20% (156 in-lbs ± 20%).
12. Adjust tilt and/or recline potentiometers. Refer to the electronics manual listed in
Reference Documents on page 2.
DETAIL "A" - CONNECTOR BRACKET MOUNTING HOLES
100°
110°
Curved Link
Shoulder Bolt
Part No 1114842
90°
Washer
Washer
Hex Bolt
FIGURE 7.1 Adjusting Back Angle
SECTION 7—BACK ADJUSTMENTS
Connector Bracket (not shown)
Locknuts
Slide Block
81
2G Tarsys®Powered Seating System
95°
105°
115°