Removing/Installing The Seat Brackets; Tilt Only And Tilt/Recline Systems - Invacare 2G Tarsys Service Manual

SECTION 5—INTERFACE HARDWARE
Shoulder Bolt
Clamp Bar
Rear Pivot Assembly
Upper Portion of
Linear Guide
Access Hole
Lower Portion of
NOTE: Front of tilt actuator
shown disassembled for clarity
only. There is no need to remove
the hardware securing the front of
the tilt actuator for this procedure.
FIGURE 5.5 Removing/Installing the Linear Guides

Removing/Installing the Seat Brackets

Tilt Only and Tilt/Recline Systems

NOTE: For this procedure, refer to FIGURE 5.6 on page 50.
Removing
1. Remove the seat assembly from the rear pivot assembly. Refer to Removing/Installing
the Seat on page 75.
2. Note the mounting location of the four hex screws and locknuts securing the front
pivot assembly to the seat brackets.
2G Tarsys®Powered Seating System
Bushings
Locknut
Socket Screw
Linear Guide
Seat Bracket
Shim
Lower Interface Bracket
Locknut
Tilt Actuator
Washer
48
Part No 1114842