Optional Four-Way Toggle Switch - Invacare 2G Tarsys Service Manual

Optional Four-Way Toggle Switch

NOTE: For this procedure, refer to FIGURE 13.3.
1. Make sure the wheelchair is on a level surface.
2. Refer to the charts which follow for the operation of the seating system using a
four-way toggle switch:
NOTE: The charts which follow show the factory programmed settings only. Switch assignments
can be reprogrammed.
SEATING SYSTEM
Tilt Only
Recline Only
Tilt/Recline
*NOTE: The four-way toggle switch will alternate functions (increase tilt angle, decrease tilt
angle) after it has been released to the neutral position for a minimum of three seconds. Refer to
MK ™ EX™ and MK
5
complete four-way toggle switch operating instructions.
NOTE: If the wheelchair is equipped with switch options, scan to the correct ECU or Auxiliary
Mode and activate the control device in the corresponding "forward" direction to operate the tilt
function. Refer to MK
for complete switch option operating instructions.
3. Release four-way toggle switch to neutral position.
Part No 1114842
FORWARD
Increase/Decrease
the Tilt Angle*
N/A
Increase/Decrease
the Tilt Angle*
TT-EX ELECTRONICS Service Manual, part number 1114808 for
5
EX and MK TT-EX Electronics Service Manual, part number 1114808,
5 5
Four-Way Toggle Switch
Rear
Right
FIGURE 13.3 Optional Four-Way Toggle Switch
SECTION 13—TILT AND RECLINE
FOUR-WAY TOGGLE SWITCH
REAR
N/A
Increase/Decrease
Increase/Decrease the Back Height
the Recline Angle*
Increase/Decrease
Increase/Decrease the Back Height
the Recline Angle
Left
LED
Forward
129
2G Tarsys®Powered Seating System
LEFT RIGHT
Power Legrest
N/A Up/Down*
Power Legrest
(VSR)* Up/Down*
Power Legrest
(VSR)* Up/Down*