Invacare 2G Tarsys Service Manual page 109

Adjusting the Calf Pad Depth
NOTE: For this procedure, refer to
FIGURE 9.6.
1. Loosen, but DO NOT remove, depth
adjustment bracket mounting screws.
2. Slide calf pad assembly up and out of
the mounting channel.
3. Remove the flat head socket screw and
locking hex nut that secure the calf
bracket to the depth adjustment
bracket.
4. Reposition the calf bracket on the depth
adjustment bracket to desired position.
5. Install the flat head socket screw
through the calf bracket, depth
adjustment bracket and locking
hex nut.
6. Tighten locking hex nut until snug. DO NOT overtighten nut or calf pad will not pivot
properly.
7. Align the two T-nuts on depth adjustment bracket assembly with channel on legrest.
8. Slide calf pad assembly to desired height. Tighten the two hex mounting screws
securely.
9. Repeat STEPS 1-6 for opposite side.
Adjusting the Calf Pad Height
NOTE: For this procedure, refer to FIGURE 9.7.
1. Loosen, but DO NOT remove, the two
hex head screws that secure depth
adjustment bracket to the T-nuts.
2. Slide the calf pad assembly with T-nuts
up or down in the channel to desired
position.
3. Holding the calf pad assembly into
position, tightly secure the hex screws
to the T-nuts.
4. Repeat STEPS 1-3 for opposite side, if
necessary.
Part No 1114842
SECTION 9—POWER ELEVATING LEGRESTS
Flat Head
Mounting
Screw
Depth
Locking
Adjustment
Hex
Holes
Nut
Depth
Adjustment
Calf
Bracket Hex
Bracket
Head Screws
NOTE: Calf pad not shown for clarity.
FIGURE 9.6 Adjusting the Calf Pad Depth
Hex Head
Screws
(T-Nuts
are NOT
SHOWN)
FIGURE 9.7 Adjusting the Calf Pad Height
109
2G Tarsys®Powered Seating System
Mounting
Channel
T-Nuts
Depth
Adjustment
Bracket
Depth
Adjustment
Bracket
Channel
Outer Rail