Invacare 2G Tarsys Service Manual page 62

SECTION 6—SEAT ADJUSTMENTS
• Use Existing Hardware to Adjust the Seat Angle Between 10° and 15° or Between
0° and 5° - Refer to Changing Seat Angle from 10° to 15° (or Vice Versa) on page 62
or Changing Seat Angle from 0° to 5° (or Vice Versa) on page 64.
• Change Hardware to Adjust the Seat Angle From 10°/15° to 0°/5° (or Vice Versa) -
Refer to Replacing Recline Links on page 65.
Rear of
Wheelchair
General
Area of
Inspection
Mounting
Hardware
10°/15° Recline
Link
FIGURE 6.6 Recline-Only Seating Systems - Preparing to Adjust the Seat Angle
Changing Seat Angle from 10° to 15° (or Vice Versa)
NOTE: For this procedure, refer to FIGURE 6.7 on page 63.
1. Make sure the wheelchair is on a level surface.
2. Remove the batteries.
3. Remove the seat pan. Refer to Removing/Installing Seat Pan on page 54.
4. Remove the retaining ring and washer that secure the 10°/15° recline link to the pin of
the seat frame. Refer to Detail "A". Discard the retaining ring.
2G Tarsys®Powered Seating System
10°/15° Recline Link
@
0°/5° Recline Link
Mounting
Hardware
62
Front of
Wheelchair
0°/5° Recline Link
Part No 1114842