Invacare 2G Tarsys Service Manual page 68

SECTION 6—SEAT ADJUSTMENTS
6. Secure the slide rod to the side frame, with the slide block in position, with the two
hex screws and washers. Torque to 13 ft-lbs ± 20% (156 in-lbs ± 20%).
NOTE: In Detail "A", the mounting position of
the hex screw on the connecting bracket shows a
back angle of 115°. For additional back angles
refer to Adjusting Back Angle on page 80.
Hex Screw
Washer
Slide Rod
Slide Block
Hex Screw
FIGURE 6.11 Preparing Side Frames for Replacement - Tilt-Only Seating Systems
Tilt/Recline and Recline-Only Seating Systems
NOTE: For this procedure, refer to FIGURE 6.12 on page 69.
1. Remove the hex screw and washer that secure the slide block to the slide block
connecting bracket.
2. Remove the two hex screws and washers that secure the slide rod to the side frame.
3. Remove the slide rod and slide block from the side frame.
4. Secure the slide rod to the side frame, with the slide block in position, with the two
hex screws and washers. Torque to 13 ft-lbs ± 20% (156 in-lbs ± 20%).
5. Secure the slide block to the slide block connecting bracket with the hex screw and
washer. Torque to 156 in-lbs ± 20%.
2G Tarsys®Powered Seating System
Connecting
Bracket
Washer
Washer
68
DETAIL "A" - INSIDE
VIEW OF CONNECTING
BRACKET ON SIDE
FRAME
Mounting Position
Locknut
Side Frame
Hex Screw
Part No 1114842