Removing/Installing Joystick(S); Removing; Installing - Invacare 2G Tarsys Service Manual

Mounting Bracket
Socket
Screws
TRSS
Joystick
Mounting
Tube
FIGURE 14.4 Replacing the Tilt Recline Single Switch (TRSS)

Removing/Installing Joystick(s)

NOTE: For this procedure, refer to FIGURE 14.5 on page 150.

Removing

1. Disconnect the joystick.
2. Turn the adjustment lock lever to release the joystick mounting tube.
3. Cut any tie-wraps securing the joystick to the seating system.
4. Remove the joystick mounting tube from wheelchair.

Installing

1. Slide the joystick mounting tube through the bracket to the desired position.
2. Slide the adjustment lock with lever over the end of the joystick mounting tube and
secure the adjustment lock to the tube by turning the adjustment lock lever.
3. Tie-wrap the joystick cable to the joystick mounting tube and to the bottom of the
armrest (not shown).
4. Connect the joystick connectors (not shown).
5. Perform the post-service inspection. Refer to Post-Service Inspection Checklist on
page 21.
Part No 1114842
Button Head Screws
149
SECTION 14—ELECTRONICS
TRSS
TRSS
Auxiliary Power
Actuator
Connector
(WHITE)
Mercury Switch Connector
(Molex Connector)
2G Tarsys®Powered Seating System
Connector