Section 10-Arms; Removing/Installing Reclining Armrests; Removing Armrests; Installing Armrests - Invacare 2G Tarsys Service Manual

SECTION 10—ARMS
SECTION 10—ARMS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Before adjusting, repairing or servicing the seating system, ALWAYS turn the
wheelchair power OFF, otherwise, injury or damage may result.
Pinch points exist between seat and base frames. Use caution, otherwise injury may
occur.
Make sure armrests are locked securely in place before using the wheelchair.
Pinch points exist on the armrests.

Removing/Installing Reclining Armrests

NOTE: For this procedure, refer to FIGURE 10.1 on page 115.

Removing Armrests

1. Lift the armrest release lever at the front of the wheelchair to the unlocked (horizontal)
position.
2. Lift the armrest and remove from the front arm socket.
3. Press the release button at the rear of the armrest.
4. While holding the release button in, remove the armrest from the seat frame.

Installing Armrests

1. Position the armrest on the seat frame as shown in FIGURE 10.1.
2. Press the release button at the rear of the armrest.
3. While holding the release button in, slide the armrest onto the seat frame.
4. Make sure the armrest release lever is in the unlocked (horizontal) position.
5. Install the armrest into the front socket.
6. Push the armrest release lever down into the locked (vertical) position.
114
2G Tarsys®Powered Seating System Part No 1114842