Invacare 2G Tarsys Service Manual page 111

2. Secure the power elevating legrest connector to the harness wire bracket using the two
cap screws and locknuts.
3. Tie-wrap the harness to the lower seat shroud (Detail "A").
4. Secure the harness to the lower seat shroud using hook and loop fastening strips.
5. Plug the harness into the TRCM 2-pin Anderson connector.
6. Repeat STEPS 2-5 for the opposite side of the wheelchair.
7. Install the power elevating legrests. Refer to Installing/Removing the Power Elevating
Legrests on page 104.
Anderson 2-Pin
Connector (To TRCM)
DETAIL "A" - TIE-WRAPS AND FASTENING STRIPS
To Right Power
Elevating Legrest
Lower Seat Shroud
Hook and Loop
Fastening Strips
To Left Power Elevating
Legrest
FIGURE 9.9 Removing/Installing the Power Elevating Legrest Harness
Part No 1114842
Seat Frame
Half Clamp
Socket Screw
Cap Screws
Harness Wire Bracket
111
SECTION 9—POWER ELEVATING LEGRESTS
Locknuts
Harness
Connector
Tie-Wraps
Tie-Wraps
2G Tarsys®Powered Seating System
Power Legrest
Connectors
Hook and Loop
Fastening Strip
To TRCM
To TRCM
Hook and Loop
Fastening Strip