Adjusting The Seat Depth With Replacing The Seat; Support Plate - Invacare FDX User Manual

5.14.4 Adjusting the seat depth with replacing the seat

support plate

Fig. 5-31 Exploded drawing of seat support
Disassembly
1. Remove the legrests.
2. Remove the armrests.
3. Remove the seat cushion.
4. Remove any cable ties which hold cables from the
remote or lighting which have been fitted. Remove the
cables from any clips which have been glued on.
5. Undo the cap nuts on the headlight holders with an
8 mm jaw spanner.
6. Place the headlights including their holders safely on
the rear section of the battery box cover.
1541361-N
7. Remove the cover plates (1).
8. Undo the two Allen screws (9) at the front on the seat
support plate and remove them.
9. Undo the two Allen screws (7) which are located on the
side at the front of the seat support plate, and connect
these to the crossmembers (4).
10. Undo the two Allen screws (8) which are located on the
side at the rear of the seat support plate, and connect
these to the crossmembers (4).
11. Remove the seat support plate (2).
12. Repeat these operations on the other side of the seat.
13. Undo and remove the two Allen screws (5) including
washers.
Assembly
1. Pull the seat support to the required length so that
the Allen screws (5) can be inserted in the holes in
accordance with the table (see above).
2. Insert the Allen screws (5) including washers again and
tighten them.
3. If necessary, replace the seat support plate (2) in
accordance with the table (see above).
4. Put the seat support plate (2) back in position.
5. Fit the two Allen screws (7) which are located at the
front of the seat support, and connect them with the
crossmembers (4).
6. Fit the two Allen screws (8) which are located at the
rear of the seat support, and connect them with the
crossmembers (4). It may be necessary to use other
holes in the 3 hole pairs for the screws than you did
while dismantling the old plate.
Setup
57