Removing/Installing The Joystick; Van Seat Models - Invacare Pronto M71 Service Manual

SECTION 11—CONTROLLER AND JOYSTICK
• On Wheelchair with SPJ-80,MPJ or DPJ Joystick - Align the joystick connector with
the controller connector and secure using the thumb screws on the joystick
connector (Detail "C" of FIGURE 11.1).
• On Wheelchairs with MPJ+ - Ensure the latch is pulled away from the joystick
connector; connect the joystick connector to the other connectors, then push the
latch in to secure the joystick connector to the other connectors (Detail "B" of
FIGURE 11.1).
DETAIL "A"
Joystick Connector
Light GREY
Collar
DETAIL "B"
NOTE: Only Van seat shown. Above procedure applies to all seats.
FIGURE 11.1 Disconnecting/Connecting the Joystick

Removing/Installing the Joystick

NOTE: If necessary, the joystick can be repositioned to the opposite armrest after being removed.

Van Seat Models

NOTE: For this procedure, refer to FIGURE 11.2 on page 99.
Removing
NOTE: Take note of position and orientation of mounting hardware for reinstalling the joystick
assembly.
1. Cut two tie-wraps securing the joystick cable to the joystick mounting tube.
Pronto® M71™
All manuals and user guides at all-guides.com
Controller
Connector
Joystick
Connector
Latch
Other
Connectors
98
DETAIL "C"
Thumb
Screws
Joystick Joystick
Connector Connector
Controller
Connector
Part No 1118377
Joystick