Removing/Installing The Joystick; Removing; Installing - Invacare At’m Service Manual

SECTION 7—JOYSTICK

Removing/Installing the Joystick

NOTE: For this procedure, refer to FIGURE 7.2.

Removing

1. Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 35.
2. Cut the tie-wraps that secure the joystick cable to the wheelchair arm and frame. Refer
to Detail "A" of FIGURE 7.2.
3. Pull the hook-and-loop fastening strap connecting the under seat basket to the chair.
4. Cut the three (3) tie-wraps that secure the joystick cable to the wheelchair frame.
5. Remove the two (2) quick-release pins that mount the joystick to the arm.
6. Remove the joystick and mounting bracket assembly.

Installing

1. Align the mounting bracket assembly with the mounting holes on the arm.
2. Install the two (2) quick-release pins that mount the joystick to the arm.
3. Secure the joystick cable to the wheelchair arm with three (3) tie-wraps. Refer to Detail
"A" of FIGURE 7.2.
4. Secure the joystick cable to the wheelchair frame with three (3) tie-wraps.
5. Secure the hook-and-loop fastening strap, over the cable and tie-wrap, to the base frame.
NOTE: Route the joystick cable under the basket upholstery to prevent it from interfering with
wheelchair motion.
6. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 35.
At'm
36
Part No. 1125078