Preparing Mk6I Joystick For Use; Removing/Installing/Repositioning Mk6I Joystick - Invacare TDX SI Service Manual

Preparing MK6i Joystick For Use

NOTE: For this procedure, refer to FIGURE 10.3.
1. Turn the adjustment lock lever to release the adjustment lock from joystick mounting
tube (FIGURE 10.3).
2. Slide joystick mounting tube to the desired position.
3. Turn the adjustment lock lever to secure the adjustment lock to the joystick mounting
tube.
Joystick Mounting
Adjustment Lock

Removing/Installing/Repositioning MK6i Joystick

NOTE: For this procedure, refer to FIGURE 10.4 on page 82.
1. Turn the adjustment lock lever to release the joystick mounting tube from the
mounting bracket.
2. Remove the rear shroud. Refer to Removing/Installing the Wheelchair Shrouds on
page 63.
3. Disconnect the joystick connector from the controller connector.
4. Cut the tie wraps that secure the joystick cable in place.
5. Remove the joystick from wheelchair.
6. If repositioning joystick, perform the following:
A. Remove the three hex head mounting screws and washers that secure both halves
of the mounting bracket to the arm tube.
B. Reposition the mounting bracket on the opposite arm tube, ensuring the threaded
plate of the mounting bracket is on the inside of the arm tube as shown.
C. Using the three hex head mounting screws and washers, secure both halves of the
mounting bracket to the arm tube.
Part No 1160845
NOTE: Joystick not shown
Mounting Bracket
Tube
Lever
FIGURE 10.3 Preparing MK6i Joystick For Use
SECTION 10—ELECTRONICS
81
TDX® SI/SI-HD