Log Set Installation - FireplaceXtrordinair 4237 EG Installation Manual

Log Set Installation

The logs are fragile, especially after exposure to heat.
NOTE: The fireplace should be in place, with the gas line and vent attached and the firebacks installed
(see owner's manual for further details).
1. Install the Ember-Glo™ glass over the perforated portion of the media tray. Place a thick layer of
the ember glass over the perforations making sure to cover all of the holes completely.
2. Lightly dress the ember glass with the black touch-up paint provided. Check the appearance
with the lights on and add additional paint, as needed, for a realistic glowing ember
appearance.

Make sure the pilot and burner are off before using paint in the firebox.
NOTE: If power is supplied to the fireplace it can help to turn the lights on while painting so you can
determine an appropriate amount of paint for a realistic ember appearance. Use the remote to
turn the Ember-Glo™ lights on and off.
NOTE: We recommend that you use a piece of paper, cardboard as a shield to mask the log grate and
burner from overspray (see below).
© Travis Industries
Installation
(for qualified installers only)
WARNING
9/22/2021 - 1561
Scan this code with a QR
reader on your cell phone to
watch a video of Ember-Glo™
glass setup.
http://vimeo.com/289322734
4237 EG
43