44
3. Once the ember glass installation is complete, place a generous amount of ember material on the
firebox floor on either side of the firebox (make sure to cover the gap between the fireback and the
media tray). Completely cover any visible metal of the media tray (not the burner).
NOTE: Make sure no ember material is placed directly on the burner.
4. Place log #1 as shown below. The two slots on the bottom of the log sit over the pin on the burner.
With the rear log in place, push it back if using LP gas or pull it forward if using NG gas.
© Travis Industries
Installation
Pull forward
for NG gas
9/22/2021 - 1561
(for qualified installers only)
Bottom View of Log
Push back
for LP gas
4237 EG