FireplaceXtrordinair 4237 EG Installation Manual page 45

5. Place log #2 on the front burner. The notch on the bottom left of the log rests on the grate.
The hole on the right end of the log rests on the locating pin just left of the center of the
burner. Push the log backward until it is in contact with the rear burner.
NOTE: Make sure the log does not obstruct any burner holes.
6. Place log #3 as shown below. The notch on the bottom right of the log rests on the grate.
The hole in the left bottom of the log rests on the locating pin just right of the center of the
burner. Push the log backward until it is in contact with the sloped portion of the rear burner.
Make sure burner holes are not obstructed.
© Travis Industries
Installation
(for qualified installers only)
9/22/2021 - 1561
45
4237 EG