FireplaceXtrordinair 4237 EG Installation Manual page 62

Hide thumbs Also See for 4237 EG:

Table of Contents

Stretch the included flex to its maximum length. Measure the distance between the starter collars on

the fireplace and the inlets on the convection manifold. Cut the flex to the appropriate length and

install between the fireplace and the manifold. Secure using (3) screws at every connection and

seal the joints with silicone caulk or aluminum (U.L. 181A-P) tape.

Cover the face of the fireplace and the outlet of the manifold to ensure no construction debris or

sheetrock dust enters the unit.

Once all finish work is complete around the outlet of the manifold, install the outlet grill assembly

using the two included screws (one at each end). The grill assembly will overlap finish material

up to 1-1/2" thick. See fireplace installation manual for finishing details.

NOTE: The manifold opening protrudes 7/16" proud of the framing. The wall may be finished to the

opening if you do not wish to use the grill trim.

Optional Equipment

9/22/2021 - 1561

Self-Drilling

Screw

4237 EG

Table of Contents