Radio Shack ADV0801 Owner's Manual page 58

ADV0801 Owner's Manual Draft
HINT: It's easy to fix things if you inadvertently change a parameter and then can't remember
how to make it right again. Each parameter includes a Dflt softkey, which, when pressed,
restores the factory default setting for that parameter.
HINT: If you think you've really messed the Global settings up, you can reset every global
parameter back to factory defaults without altering your programmed objects. Turn the radio off,
then on again. While the "Welcome" screen is being displayed, press and release 0, then press
and release 2. Press ENT to confirm the reset of all global parameters to their factory defaults.
NOTE: The Special Global Settings menu (FUNC GLOB) includes parameter settings that, if
not set properly, may adversely affect the performance of your radio. We recommend that users
not change the settings found in the FUNC GLOB menu unless instructed to in this manual.
Should you experience difficulties after changing any of the settings in the FUNC GLOB menu,
you can also restore those settings to factory defaults by pressing the Dflt softkey associated
with each menu line, or following the 0,2 global settings reset procedure described above.
GLOB Menu Reference
The GLOB menu stores all of the radio-wide settings used by the scanner. The GLOB menu
allows you to "tweak" these settings to your liking. The default settings will work fine for most
users, but most users will want to use the GLOB menu to personalize the radio to suit their
individual tastes. The active parameter is always the middle parameter and is indicated by a
flashing ":". The entire GLOB menu is shown below. Note that some GLOB parameter changes
do not take effect until the GLOB menu is saved.
HINT: You can restore all GLOB settings to their defaults without affecting your programmed
objects or V-Scanners. Power cycle the radio, then press 0, then 2 during the welcome message
display. Press ENT to confirm the GLOB parameter reset.
GLOB Parameter
CONTRAST
Owner
Clone Send
Alert Mode
Sound Mode
Options Description
1-7
Sets LCD contrast. Use < > keys on 5-way pushbutton pad.
SEL
Enters sub menu to set Welcome Message text display.
SEL
Press SEL to send data using clone mode
Both, Tone, Light, Off
Controls the ALERT LED and Audible Alarm behavior.
Both allows the LED and Tone. Tone allows the audible
alarm only. Light allows the LED only. Off deactivates the
ALERT LED and Audible Alarm feature.
Page 58