Radio Shack ADV0801 Owner's Manual page 71

ADV0801 Owner's Manual Draft
Atten
Delay
Delay Time
Zeromatic
Search Dir
Hit Count
SRVC Menu Reference
The SRVC menu is used when creating new Service Search objects, or editing existing Service
Search objects. All menus are shown in the scanner's display as a three line window that can be
scrolled up or down to access the various different parameters. The active parameter is always
the middle parameter and is indicated by a flashing ":". The entire SRVC menu is shown below:
SRVC Parameter
Scan Lists
Srvc
AM, FM, NFM, AU
Modulation setting for the LMIT search. In most cases AU
will work fine. Use AM to override and force AM
modulation, FM to force FM modulation, NFM to force
narrow FM modulation.
On or Off
When on, applies 20 dB of attenuation to all hits received
on the LMIT search. Useful in areas where interference
from nearby strong signals is present.
On or Off
Controls whether a Delay is used to wait for reply traffic
after a transmission is received during the LMIT search.
1-200
Sets the amount of time (in 100 millisecond intervals) for
the wait for reply delay if Delay is On, e.g., 20=2 seconds.
On or Off
When on, enhances the scanner's ability to lock on to the
actual center frequency of a search hit instead of an
adjacent frequency.
Up or Down
Sets search direction used when LMIT object is active.
Numeric value
Increments each time a transmission is received on the
LIMT object. Global "Hit Counts" must be set to ON. Press
the Dflt softkey to reset to 0.
Options Description
On or Off for Scan Lists 1-20
Sets membership in Scan Lists. Use < > keys to scroll
through Scan Lists. Use SEL key to toggle Scan List
membership. A "*" next to the Scan List number indicates
that the object is mapped to that Scan List.
Page 71