Radio Shack ADV0801 Owner's Manual page 56

ADV0801 Owner's Manual Draft
1. Turn off the scanner, then turn it on again. The scanner briefly displays the DSP boot version,
and then the Welcome/Owner screen is displayed.
2. Press 0 while the scanner is displaying the Welcome/Owner screen. The scanner displays
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press 2. The scanner displays
Init GLOB data
To factory state
ENTER if APPROVE
CLEAR to EXIT
4. Press ENT. The scanner displays
GLOB EEPROM area
Initialized to
defaults.
Press any key.
5. Press any key on the keypad to proceed. The scanner will reboot with file system and global
parameters reset to factory defaults.
Initializing the Scanner to Factory Defaults
If initializing the global parameters to factory defaults does not resolve your problem, you may
wish to initialize the entire scanner to factory defaults. This operation will result in the clearing
of your programmed data and the loss of any custom changes you have made to the radio's
global parameters. Use this option as a last result, and, if possible, save your working memory
to a V-Scanner folder prior to performing this operation.
NOTE: This procedure clears all information you stored in the scanner's working memory, AND
resets the global parameters to factory defaults. Initialize the scanner only when you are sure
the scanner is not working properly. V-Scanner memory is not affected when the scanner is
initialized.
1. Turn off the scanner, then turn it on again. The scanner briefly displays the DSP boot version,
and then the Welcome/Owner screen is displayed.
2. Press 0 while the scanner is displaying the Welcome/Owner screen. The scanner displays
System Tests:
Select a Test...
Page 56