The Menu Command "System - System Settings - Siemens SIMATIC RF166C Operating Instructions Manual

Configuration using the WBM
7.3 The menu items of the WBM
Note
Restrictions when transferring the configuration
Note that you as "User" can only transfer changes when the device status of the
communication module is "Idle". As an "administrator", you can also transfer changes even
when the device status is "Run".
The following table provides you with an overview of the menu items that are restricted for
the "User" role:
Table 7- 20
Menu items
Start page
Diagnostics
Edit transponder
User management
System
In addition, changes cannot be transferred to the communication module using the "Transfer
configuration to communication module" button.
User management on / off
Click the "Disable user management" button if you want to disable user management again.
Note that any user has all read/write privileges (administrator rights) when user
administration is disabled.
7.3.11

The menu command "System - System settings"

In the "System - System Settings" menu item, you can update firmware, reset the
communication module to the factory settings, change the IP address of the communication
module, load certificates on the communication module and transfer control files to the PC.
This page is divided into the following areas:
● Firmware update
● Reset
● IP address
92
Restrictions for the "User" role
Hardware diagnostics
Log
Syslog log
Restrictions
Restricted:
•
Input boxes cannot be filled.
No operator control is possible in the "Run" device status.
•
No operator control is possible in the "Run" device status.
Restricted:
The log cannot be reset.
The page is not displayed.
No operator control is possible in the "Run" device status.
Restricted:
Only the user's own password can be changed.
No operator control is possible in the "Run" device status.
Operating Instructions, 12/2019, C79000-G8976-C578-01
SIMATIC RF166C