Groomer Plate Assembly - Toro Reelmaster 6500-D Service Manual

Groomer Plate Assembly

Loctite #242
7
21
20
16
21
22
23
24
RIGHT
FRONT
1. Groomer reel
2. Pulley spacer
3. Washer (as required)
4. Square key
5. Driven pulley
6. Flange nut
7. Socket head screw
8. Idler plate
NOTE: The groomer reel drive is located on the oppo-
site side of the cutting unit from the cutting reel hydraulic
motor. Figure 4 shows components used when the
groomer reel drive is on the left side of the cutting unit.
Note: Early production groomer shafts and driven pul-
leys were equipped with a square key. Later production
components are shown in Figure 4.
Removal (Fig. 4)
1. Park machine on a clean and level surface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
DPA Groomer
1
Antiseize
Lubricant
Figure 4
9. Idler pulley assembly
10. Lock nut
11. Flange head screw
12. Drive pulley
13. Retaining ring
14. Extension spring
15. Pivot hub assembly (drive)
16. O- -ring
Page 7.3 - - 6
2
3
5
6
23
17 to 21 ft- -lb
(23 to 28 N- -m)
17. Groomer plate (drive)
18. Groomer shim
19. Cutting reel
20. Pivot hub assembly (non- -drive)
21. Flange nut
22. Groomer plate (non- -drive)
23. Excluder seal
24. O- -ring
NOTE: If cutting unit is equipped with powered rear roll-
er brush, removal of roller brush components will be
necessary to service groomer plate assemblies (see
Roller Brush (Optional) in the Service and Repairs sec-
tion of Chapter 7.2 -- DPA Cutting Units).
2. To remove groomer plate assembly from groomer
drive side of cutting unit:
A. Remove groomer belt cover and groomer drive
belt from groomer drive (see Groomer Belt Replace-
ment in this section).
NOTE: To prevent cutting reel from turning when re-
moving drive pulley, block reel with piece of wood.
Rev. E
19
Antiseize
Lubricant
18
17
Loctite #242
16
7
4
14
13
15
7
8
9
10
Loctite #242
27 to 32 ft- -lb
(37 to 43 N- -m)
Reelmaster 6500--D/6700--D
12
11